DTG Kiosk Spécifications télécharger pdf (Page 52)

start to blink.

6. Release the Roll Paper and Sheet buttons.

7. Then, press

ONLY the Roll Paper button for 10 seconds.

8. The Power light and Ink lights will turn solid in colour and remain permanently on, and

then the Print Head will start to move.

9. Turn OFF the unit at the Power button on the circuit board. Let the Print Head return to

the park position and then turn ON the unit at the Control Panel Power button.

10. Replace the blue cover.

Please Note: Please call our Support Office if you have ANY problems at all in carrying out this

procedure and they will walk you through the process.

12.4 Replacing Waste Ink Pad

On the left inside shelf of the printing unit there is a small ink pad on that is used to

occasionally wipe the bottom of the print head. Your DTG Kiosk package included a small

replacement pad to be used when the pad becomes full of ink. When ready to be replaced, just

pry the old pad out and press the new pad in place.

12.5 If Printer is Not Used for Some Time

If the printer is to be left idle for a long period of time (1 – 2 weeks), then you should flush the

system with flushing solution – please see the section on “transporting your printer” for

instructions on flushing the system of ink. Do not leave ink in the system unused for a long

period of time.

12.6 Print Head Replacement

If the Print Head hits against the metal Holding Ring or is damaged in some other way, you will

probably have to replace it. You will know that it is permanently damaged when you do a Print

Alignment and you can’t get the head to print in alignment after numerous attempts. It is quite

a simple process to replace the head and it will take you less than 30 minutes. Replacement

heads are available from Impression Technology for an approximate cost of $400 and come with

complete written and DVD replacement instructions. It would be advisable to keep a

replacement Head in stock if you cannot afford for your DTG Kiosk to be out of action for a few

days.

12.7 Diagnosing Printer Problems

o Green POWER light is flashing

The green light will flash when the printer is receiving data, cleaning the print head,

replacing an ink cartridge, or charging ink.

o ERROR EJECT button light is on

The printer has received an error in the data, or there is no media loaded, or there is a

wrong size sheet feed. Only press the Error Eject button at the loading position instead of

the Load button.

o Red INK light flashes

Turn the printer off and on to reset the Printer.

o Green POWER button, ERROR EJECT button flashing

This means the printer is being jammed or blocked by a foreign object that must be

removed before continuing.

o LOAD button and green POWER button turn on after the printer is in the loading

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 61 62

Commentaires sur ces manuels

Pas de commentaire

DTG Kiosk Spécifications Page 52

Commentaires sur ces manuels