DTG Kiosk Spécifications télécharger pdf (Page 51)

8. If pattern 4 has the least noticeable banding, click Next. If there was another

pattern that was better, enter that number and click on Realignment to print out

another test page.

9. After the test page has been printed, remove and reload the test page with pattern

set 1 on the right side.

10. Click Print to print the pattern on the next test page.

11. When that test page has printed out, reload it again to print the next test.

12. Repeat these steps until you have a third test pattern.

13. Once all test prints are done, select the least grainy box in each set. Put these

numbers in the Print Head Alignment window.

14. If Box 3 is the least grainy in

all the rows, click Finish. If Box 3 is the best in one or

more rows, but you still need to adjust other rows, clear the checkbox for the rows

with 3 and click on Realignment. This will print out another test page for the rows

that were left checked.

12.2 Waste Pad Replacement and Waste Ink Bottle Maintenance

During the Head Cleaning process your DTG Kiosk™ forces ink through the print head. This

excess ink goes into a holding bottle called the Waste Ink Bottle, accessible through the door

on the right front side of the printer below the control panel. Check this bottle regularly, and

empty it when it is getting full or before an ink flush or ink fill procedure. Remember you must

comply with local regulations in disposing of its contents.

Occasionally your printer might decide you have used enough ink to have filled the entire Waste

Ink Bottle, even though it may be empty. If your printer thinks you have done about 10,000 to

15,000 “pages” it will feel it is time to empty the excess ink that should have accumulated

here. At this point all of the ink lights will blink without an obvious way to reset the counters

and you will not be able to run the printer until you empty the Waste Ink Bottle and re-set the

Ink Counter in the printer.

12.3 Resetting Ink Counter

While there is an Ink Counter Reset process available on your SSC Service Utility (Windows only)

it is not very reliable so we recommend you use the following instructions to reset the Ink

Counter:

1. Turn off the printer. If it doesn’t respond when you turn it off at the Power button just

proceed to the next step.

2. Remove the blue cover on the Control Panel side of the printer. There are five small

screws including one on the upper back side of the unit.

3. Carefully slide the blue cover up and off the unit. The original Epson 2100/2200 buttons

sit below the Control Panel.

4. Turn the unit OFF at the Power button on this small circuit board. This board is low

voltage.

5. Hold down the Roll Paper and Sheet Buttons and then turn the Power button ON (at this

circuit board). The Power light, Error Eject and Ink lights on the main Control Panel will

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 61 62

Pas de commentaire

DTG Kiosk Spécifications Page 51